Test ID Found Event
The Test ID Found event (see "Test ID") occurs when a valid Test ID has been recognized. A valid Test ID must meet the level, frequency, duration, and delimiter requirements. If any of these parameters do not match, the process is terminated and is reset to the initial conditions.
Note: Until a Test ID is successfully recognized, the system will continue to operate in Non-Referenced Mode; therefore, no events related to false starts are reported. This is because for arbitrary audio there is no expectation of any Test ID.
The info reported with the Test ID Found event is listed below:
- Info1: The Test ID
-
Info2: The measured RMS average audio of the 400 Hz terminator tone. This level can be converted to dBFS by the relationship
.Optionally the value can be converted to “Channel Gain” via the relationship
. - Msg: The measured frequency [Hz] of the terminator tone.