About AVDTP Decoder Parameters

Each entry in the Set Initial Decoder Parameters window takes effect from the beginning of the capture onward or until redefined in the Set Subsequent Decoder Parameters window.

The AVDTP tab requires the following user inputs to complete a parameter:

• Piconet (Data Source (DS) No.) - When only one data source is employed, set this parameter to 0 (zero), otherwise, set to the desired number of data sources.
• Role - This identifies the role of the device initiating the frame (Master or Slave)

• L2CAP Channel - The channel number 0 through 78.

  • L2CAP channel is Multiplexed - when checked indicates that L2CAP is multiplexed with upper layer protocols.

• AVDTP is carrying - Select the protocol that  AVDTP traverses to from the following:

• AVDTP Signaling
• AVDTP Media
• AVDTP Reporting
• AVDTP Recovery
• -Raw Data-
  

Adding, Deleting, and Saving AVDTP Parameters

1. From the Set Initial Decoder Parameters window, click on the AVDTP tab.
2. Set or select the AVDTP decoder parameters.

3. Click on the ADD button. The Intial Connection window displays the added parameters.

   

   Parameters Added to Decoder

4. To delete a parameter from the Initial Connections window, select the parameter and click on the Delete button.
5. Decoder parameters cannot be edited. The only way to change a parameter is to delete the original as described above, and recreate the parameter with the changed settings and selections and then click on the Add button.
6. AVDTP parameters are saved when the template is saved "Adding a New or Saving an Existing Template"

Also see these related topics...