L2CAP Override Decode Information
The Set Subsequent Decoder Parameters dialog allows the user to override an existing parameter at any frame in the capture where the parameter is used.
If you have a parameter in effect and wish to change that parameter:
-
Select the frame where
the change should take effect - Select Set Subsequent Decoder Parameters from the Options menu, or by selecting a frame in the frame display and choosing from the right-click pop-up menu, and make the needed changes. Refer to
- Change the L2CAP parameter by selecting from the rule to change, and click on the listed parameters.
- If you wish to remove an overridden rule click on Remove Override button. If you want to remove all decoder parameter settings click on Remove All.
- Click OK.
Each entry in the Set Subsequent Decoder Parameters dialog takes effect from the specified frame onward or until redefined in this dialog on a later frame.
Note: If the capture has no user defined overrides, then the system displays a dialog stating that no user defined overrides exist.